Ultimate Guide to Prepare 156-585 Certification Exam for CCTE in 2022
Use Real 156-585 Dumps - CheckPoint Correct Answers updated on 2022
CheckPoint 156-585 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
NEW QUESTION 52
Where do Protocol parsers register themselves for IPS?
- A. Passive Streaming Library
- B. Other handlers register to Protocol parser
- C. Context Management Infrastructure
- D. Protections database
Answer: A
NEW QUESTION 53
VPN issues may result from misconfiguration, communication failure, or incompatible default configurations between peers Which basic command syntax needs to be used for troubleshooting Site-to-Site VPN Issues?
- A. vpn truncon debug
- B. vpn debug truncon
- C. fw debug truncon
- D. cp debug truncon
Answer: B
NEW QUESTION 54
What table does the command "fwaccel conns" pull information from?
- A. SecureXLCon
- B. sxl_connections
- C. cphwd_db
- D. fwxl_conns
Answer: D
NEW QUESTION 55
You are upgrading your NOC Firewall (on a Check Point Appliance) from R77 to R80 30 but you did not touch thesecuritypolicy After the upgrade you can't connect to the new R80 30 SmartConsole of the upgraded Firewall anymore What is a possible reason for this?
- A. the upgrade process changed the interfaces and IP adresses and you have to switch cables
- B. the license became invalig and the firewall does not start anymore
- C. new new console port is 19009 and a access rule ts missing
- D. the IPS System on the new R80.30 Version prohibits direct Smartconsole access to a standalone firewall
Answer: D
NEW QUESTION 56
Which command can be run in Expert mode to verify the core dump settings?
- A. grep $FWDIR/config/db/initial
- B. grep cdm /config/db/initial
- C. grep cdm /config/db/coredump
- D. cat /etc/sysconfig/coredump/cdm.conf
Answer: A
NEW QUESTION 57
How many captures does the command "fw monitor -p all" take?
- A. All 4 points of the fw VM modules
- B. The -p option takes the same number of captures, but gathers all of the data packet
- C. All 15 of the inbound and outbound modules
- D. 1 from every inbound and outbound module of the chain
Answer: C
NEW QUESTION 58
Which file is commonly associated with troubleshooting crashes on a system such as the Security Gateway?
- A. core dump
- B. tcpdump
- C. CPMIL dump
- D. fw monitor
Answer: A
NEW QUESTION 59
Which command do you need to execute to insert fw monitor after TCP streaming (out) in the outbound chain using absolute position? Given the chain was 1ffffe0, choose the correct answer.
- A. fw monitor -p0 -ox1ffffe0
- B. fw monitor -po 1ffffe0
- C. fw monitor -p0 ox1ffffe0
- D. fw monitor -po -0x1ffffe0
Answer: D
Explanation:
Explanation
https://sc1.checkpoint.com/documents/R80.40/WebAdminGuides/EN/CP_R80.40_PerformanceTuning_AdminG
NEW QUESTION 60
Which of the following inputs is suitable for debugging HTTPS inspection issues?
- A. fw debug tls on TDERROR_ALL_ALL=5
- B. vpn debug cptls on
- C. fw diag debug tls enable
- D. fw ctl debug -m fw + conn drop cptls
Answer: D
NEW QUESTION 61
Check Point provides tools & commands to help you to identify issues about products and applications. Which Check Point command can help you to display status and statistics information for various Check Point products and applications?
- A. cpstat
- B. CPview
- C. CPstat
- D. fwstat
Answer: A
NEW QUESTION 62
James is using the same filter expression in fw monitor for CITRIX very often and instead of typing this all the time he wants to add it as a macro to the fw monitor definition file. What's the name and location of this file?
- A. $FWDIR/conf/fwmonltor.def
- B. $FWDIR/lib/fwmonltor.def
- C. $FWDIR/lib/tcpip.def
- D. $FWDIR/lib/fw.monitor
Answer: B
NEW QUESTION 63
Which of the following is contained in the System Domain of the Postgres database?
- A. User modified configurations such as network objects
- B. Trusted GUI clients
- C. Configuration data of log servers
- D. Saved queries for applications
Answer: B
NEW QUESTION 64
Which one of the following is NOT considered a Solr core partition:
- A. CPM_0_Revisions
- B. CPM_0_Disabled
- C. CPM_Gtobal_R
- D. CPM_Global_A
Answer: C
NEW QUESTION 65
When a User Mode process suddenly crashes it may create a core dump file. Which of the following information is available in the core dump and may be used to identify the root cause of the crash?
i Program Counter
ii Stack Pointer
ii. Memory management information
iv Other Processor and OS flags / information
- A. i and n only
- B. D Only iii
- C. iii and iv only
- D. i, ii, lii and iv
Answer: C
NEW QUESTION 66
When debugging is enabled on firewall kernel module using the 'fw ctl debug' command with required options, many debug messages are provided by the kernel that help the administrator to identify issues. Which of the following is true about these debug messages generated by the kernel module?
- A. Messages are written to /etc/dmesg file
- B. Messages are written to $FWDIR/log/fw.elg
- C. Messages are written to a buffer and collected using 'fw ctl kdebug'
- D. Messages are written to console and also /var/log/messages file
Answer: D
NEW QUESTION 67
Vanessa is reviewing ike.elg file to troubleshoot failed site-to-site VPN connection After sending Mam Mode Packet 5 the response from the peer is PAYLOAD-MALFORMED" What is the reason for failed VPN connection?
- A. The authentication on Phase 1 is causing the problem
Pre-shared key on local gateway encrypted by the hash algorithm doesn't match with the hash on the peer gateway generated by encrypting its pre-shared key created in Packet 1 and Packet 2 - B. The authentication on Phase 1 is causing the problem.
Pre-shared key on local gateway encrypted by the hash algorithm created in Packet 3 and Packet 4 doesn't match with the hash on the peer gateway generated by encrypting its pre-shared key - C. The authentication on Quick Mode is causing the problem
Pre-shared key on local gateway encrypted by the hash algorithm created in Packets 3 and 4 doesn't match with the hash on the peer gateway generated by encrypting its pre-shared key - D. The authentication on Phase 2 is causing the problem
Pre-shared key on local gateway encrypted by the hash algorithm created in Packets 1 and 2 doesn't match with the hash on the peer gateway generated by encrypting its pre-shared key
Answer: D
NEW QUESTION 68
What does CMI stand for in relation to the Access Control Policy?
- A. Content Management Interface
- B. Context Management Infrastructure
- C. Content Matching Infrastructure
- D. Context Manipulation Interface
Answer: B
NEW QUESTION 69
What command sets a specific interface as not accelerated?
- A. nonaccel -s <interface1>
- B. fwaccel exempt state <interface1>
- C. fwaccel -n <intetface1 >
- D. noaccel-s<interface1>
Answer: A
NEW QUESTION 70
What is the proper command for allowing the system to create core files?
- A. service core-dump start
- B. $FWDIR/scripts/core-dump-enable.sh
- C. >set core-dump enable
>save config - D. # set core-dump enable
# save config
Answer: C
NEW QUESTION 71
What is connect about the Resource Advisor (RAD) service on the Security Gateways?
- A. RAD is completely loaded as a kernel module that looks up URL in cache and if not found connects online for categorization There isno user space involvement in this process
- B. RAD is not a separate module, it is an integrated function of the 'fw1 kernel module and does all operations in the kernel space
- C. RAD has a kernel module that looks up the kernel cache, notifies client about hits and misses andforwards a-sync requests to RADuser space module which is responsible for online categorization
- D. RAD functions completely in user space The Pattern Matter (PM) module ofthe CMI looks up for URLs in the cache and if not found, contact the RAD process inuser space to do online categorization
Answer: D
NEW QUESTION 72
What does SIM handle?
- A. OPSEC connects to SecureXL
- B. FW kernel to SXL kernel hand off
- C. Hardware communication to the accelerator
- D. Accelerating packets
Answer: C
NEW QUESTION 73
When a User process or program suddenly crashes, a core dump is often used to examine the problem. Which command is used to enable the core-dumping via GAIA dish?
- A. set user-dump enable
- B. set core-dump enable
- C. set core-dump per_process
- D. set core-dump total
Answer: D
NEW QUESTION 74
......
CCTE -156-585 Exam-Practice-Dumps: https://pass4sure.examcost.com/156-585-practice-exam.html
